Hot rolled to IS 2062:2011 Grade E250A standards, the G D Metsteel MS Equal Angle G D Metsteel E250A MS Angle - 100 x 100 x 6 mm presents equal legs of 100x100 mm with 6 mm wall thickness in a standard 12 m length. The hot rolling process ensures uniform grain flow and predictable E250A mechanical performance, providing structural engineers with a dependable design section for frames, trusses, towers, and secondary steelwork. Supplied with a clean mill finish, this equal angle is ready for painting, galvanizing, or direct use in both indoor and outdoor structural applications.

• IS 2062:2011 Grade E250A certified with traceable mill test reports
• Symmetric equal legs simplifying structural analysis and connection detailing
• 250 MPa minimum yield strength for confident structural design calculations
• 410 MPa UTS ensuring sufficient tensile reserve in load-bearing members
• Hot rolling process delivering uniform grain structure across the cross-section
• Low carbon equivalent supporting good field weldability and bending operations
• Standard 12 m lengths for efficient procurement, transport, and site scheduling
• Surface free from major rolling defects; ready for fabrication and protective coating
• Equal leg geometry allowing simultaneous bolt patterns on both flanges
• Corrosion protection achievable through painting, priming, or galvanizing treatment

• Load-bearing trusses and space frame structural chord and bracing members
• Primary and secondary framing in pre-engineered and conventional steel buildings
• Mezzanine floor edge framing, platform edging, and stair construction members
• Equal angle lattice bracing in transmission tower and telecom mast structures
• Industrial conveyor supports, chute framing, and material handling structures
• Construction scaffolding, temporary works, and false work angular members
• Agricultural sheds, greenhouses, and rural infrastructure structural framing
• Shipbuilding secondary structure, deck framing, and bulkhead stiffener angles